Insulating and antifriction parts for machine building by drawing
We manufacture parts from cast nylon, textolite, glass-textolite, PTFE, polyurethane, and other materials for industrial equipment, machine tools, drive systems, and friction units.
A plastic part in machine building is an engineering solution for a specific node. A cast-nylon bushing can outlast a bronze one under insufficient lubrication. A textolite gear reduces noise compared to a metal one. A glass-textolite gasket carries load and provides electrical insulation at the same time.
Industry requirements
Geometric stability
Parts operating in nodes with minimal clearances require precise conformance to the drawing from batch to batch. Before production, we verify tolerances, mounting dimensions, and the achievability of requirements with the chosen material.
Interchangeability
We work to an approved drawing. If the drawing diverges from the sample, we clarify this before production.
Small and medium batches
We manufacture parts starting from 1 unit. The price per unit depends on material, geometry, processing method, and run size. The quote specifies the batch cost and, if needed, calculation options for different volumes.
Typical parts
- bushings
- washers
- gaskets
- gears
- guides
- strips
- plates
- complex-shape parts
Materials
- cast nylon PA-6/PA-6-MO
- textolite
- glass-textolite
- PTFE
- polyurethane
Send drawing for a quote
If marked as urgent, we reply within 6 hours during business hours. If you submitted after 5 pm, the quote comes in the morning.