Electrical-insulation parts for electrical engineering and energy by drawing
We manufacture electrical-insulation parts for transformers, reactors, switchgear, busbars, high-voltage bushings, cable couplings, and other power equipment.
Key industry requirements
Heat-resistance class
Heat-resistance class per GOST 8865 and IEC 60085 is critical: A — 105°C, B — 130°C, F — 155°C, H — 180°C. Specify the class in the drawing or TS. If not specified, we select the material based on operating temperature and node requirements.
Dielectric properties
Electrical strength, volume resistivity, and dielectric loss tangent are critical for equipment. Properties are confirmed by the material certificate.
Manufacturing precision
For parts operating in high-voltage zones, thickness, geometry, mounting dimensions, and batch stability are critical. We manufacture parts with tolerances down to 0.01 mm where the material, geometry, and drawing requirements permit.
Typical parts and materials
| Part | Material | Conditions | Application |
|---|---|---|---|
| Insulating gaskets | STEF, STEF-1, EPGC 201 | Up to 155°C, class F | Transformers, reactors |
| Insulating washers | STEF, STEF-U | Up to 130°C, class B | Switchgear, busbars |
| Insulating bushings | STEF, EPGC 203 | Up to 180°C, class H | High-voltage bushings |
| Partitions | EPGC 308/G11 | Up to 180°C, moisture-resistant | Switchgear 6–35 kV |
| Slot wedges | Durostone UPM 203 | Up to 180°C, flame-retardant | Motor windings |
| Cylinders and tubes | TSEF, TSPV | Up to 155°C | Coils, transformer windings |
Send drawing for a quote
If marked as urgent, we reply within 6 hours during business hours. If you submitted after 5 pm, the quote comes in the morning.